WitrynaThis is done by the cisco proprietary Inter-Switch Link (ISL) trunk encapsulation protocol or the IEEE Standard 802.1q (dot1q) trunk encapsulation protocol. As a CCNA you will be required to understand the operation of both trunk encapsulation protocols and how to configure, verify and troubleshoot trunks links using either ISL or Dot1q. IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames. The standard also contains provisions for a quality-of-service prioritization scheme commonly known as IEEE 802.1p and defines the Generic Attribute Registration Protocol.
Cisco router dot1Q monitoring - Network Engineering Stack Exchange
WitrynaJust to add a little bit onto what Joshua was saying. cisco has a proprietary Inter switch link (ISL) and Ieee came out with 802.1q a little while after. Most of the newer switches (ie the ones you have bought) may/do not support ISL anymore and default to dot1q. Hope that helps out with you problem and always double check your configurations. Witryna7 mar 2024 · ISL uses more processor cycles than 802.1q because of the modification of the header and recalculation of FCS. Les intensive than ISL. Native frame. ISL does … goodman victorville
switchport trunk encapsulation dot1q not working on new cisco …
Witryna30 mar 2024 · Use the vlan dot1q tag native global configuration command to configure the edge switches so that all packets going out an IEEE 802.1Q trunk, including the native VLAN, are tagged. If the switch is configured to tag native VLAN packets on all IEEE 802.1Q trunks, the switch drops untagged packets, and sends and receives only … WitrynaA. With both ISL and Dot1Q and only Dot1Q : Here note the packet size as well. After finishing negation: All Packets are send and receive between both switches are Dot1Q. Here, Dot1Q will because we configured as Admin forced for Dot1q. Note: Here: You can change from the default with the switchport trunk encapsulation command. Witryna19 sty 2024 · Background Information. This document provides a sample configuration of IEEE 802.1Q (dot1q) trunking between a Cisco Catalyst 3550/3560/3750 switch that runs Cisco IOS ® Software and a Catalyst 6500/6000 series switch or Catalyst 4500/4000 series switch that runs Cisco IOS Software. Trunking is a way to carry … cheshire tm520